Chapter 3: inspection, adjustment, and lubrication
1. Note the path of the old cable, loosen the brake cable anchor bolt, and remove the worn cable.
2. Grease the new cable and reinstall, feeding it along the same path as the old cable, including through the cable anchor bolt.
Make sure the leaded cable-end is seated properly in the lever, and the housing is properly seated in the lever and all the housing stops.
If needed, follow the instructions to align the brake pads.
3. Turn the adjusting barrel clockwise so the threads on the adjusting barrel are not exposed above the caliper, or outside the lever.
4. Hold the brake pads against the rim, pull the cable snug, and tighten the cable clamp bolt to the torque specification.
5. Cut the cable so that no more than 2 inches (51 mm) extends beyond the anchor bolt.
6. Crimp a metal cap or place a bit of solder on the end of the cable to prevent fraying.
7. Follow the instructions for inspection and adjustment for your brake type.